The creation of electronic dog fence Petsafe only takes a couple of minutes. Suggested locations for the transmitter include attics, closets and garages. It may be easily connected to a 110-volt outlet, and the radio signal can still transmit through obstacles such as walls. Using radio signals, the fence correction will provide electronic dog if the dog crosses the border.

Here is a simple how-to on installing electronic billboards Petsafe specific dog:

Choosing the location of the transmitter

The transmitter should be laid in a dry and well ventilated, and the location sure. Avoid places where temperatures can reach freezing point. Metallic surfaces or objects can interfere with radio transmission and that its location should be at least 3 feet from any metal surface.

Transmitter Mounting

You can mount the transmitter on the wall chosen or a wooden table. Must be 2 to 4 feet above the ground. You can directly connect the power cord into the transmitter and the other end into the electrical outlet.

Prepare the Collar

The necklace in the kit comes with 2-pin correction applies electricity to your dog. Tighten bolts. You may need more time pins if you have dogs with long hair.

In installing the battery, push the battery into the case, you can use a coin in it. Turn the battery slot until the arrow aligns with the lock symbol on the case.

The necklace, by default, is set to sound only, so you need to establish the level of correction to ensure your dog receives the shock correction. You can consult the manual changes in configuration.

To do this, remove the cap on the upper neck and turn it counterclockwise. You will see the correction level button and hold until you see the power LED light in front of case. The flash light level based on the correction you want. For example, if you want the level 3 correction, the light flashes 3 times.

There are 6 levels in the electronic kit Petsafe dog fence. Level 1 is a simple sound to most behaved dogs, 2 for a quiet and shy dog, 4 for the average energy dogs, and 6 for dogs mischievous and energetic. Levels 3 and 5 are awaiting correction.

Creation of the Border

A circular boundary is created by the transmitter, because it sends a radio signal in all directions. It was installed in the area where you want your dog to be contained.

Adjust the level of neck to 1, first and takes the edge of the chosen limit. While his back to the transmitter location, keep the neck at the neck of his dog. You can leave a wizard set the limit level "if the closest desired limit is 45 feet or less and" high "if greater. You can set the flags at the border and let your dog know that goes flags beyond the means of correction.

About the Author:

Electronic dog fence
with Waterproof Receiver available at
http://www.petdepotonline.com

Article Source: ArticlesBase.com – How to Easily Install Petsafe Electronic Dog Fence